To install Client Service for NetWare

1. Open Network Connections.
2. Right-click the local area connection for which you want to install Client Service for NetWare, and then click Properties.
3. On the General tab, click Install.
4. In the Select Network Component Type dialog box, click Client, and then click Add.
5. In the Select Network Client dialog box, click Client Service for NetWare, and then click OK.

Important

• XOX XOX

Notes

• XOX
• When you install Client Service for NetWare, it is installed for all connections. If you do not want Client Service for NetWare installed for a certain connection, view the properties for that connection and then clear Client Service for NetWare.
• Client Service for NetWare does not support the IP protocol and therefore cannot be used to interoperate with NetWare in an IP-only environment. You must run the IPX protocol on the NetWare server, or use a redirector that is compatible with NetWare Core Protocol (NCP) and that supports native IP.
• To test that Client Service for NetWare has been initialized properly, at a command prompt, type net view /network:nw. You should see a list of available NetWare servers.
• When Client Service for NetWare is installed, the NWLink IPX/SPX/NetBIOS Compatible Transport protocol is also installed.